Step 7: Nail the surface on the front and rear panel
You cannot nail or screw to the plywood surface, so you need to create nailed characters. These should comply with the circumference of both the back and the front. To do this, you start by cutting four 2 × 4 shapes that are 20 inches long. You will then place them flat on the sides of the panel. From them, you can go to the other side and nailed them into places.
Do your best to confirm that your panels are centered. It's not that you would create a too crooked dog home otherwise, but you could run into problems later. Think of the center to reduce the barn maintenance time you will have to do as soon as the dog arrives. Yes, there is also a dog house maintenance service!
